Resin Type: enhanced linear low density polyethylene, slip, antiblock and processing aid additivesCharacteristics: excellent dart impact, hot-tack and heat seal properties, good drawdown, can be used straight or blended with LDPE or HDPEApplications: thick or thin film applications where excellent toughness and abuse resistance, hot-tack and heat seal properties are requiredNatural ColorSlip: 1000 ppmAntiblock: 6000 ppm.Recommended processing conditions: 6.35 cm extruder. 24:1 screw L/D ratio. 0.203 cm die opening. Melt temperature 232°C. Blow up ratio 2.5:1. Output rate 8.0 lb/hr/in die cir.Hot-Tack Initiation Temperature: 91°CUltimate Hot-Tack Strength: 3 NHeat Seal Initiation Temperature at 0.5 lb.: 97°CUltimate Heat Seal Strength: 11.1 N.Film properties based on thickness of 0.0318 mm.Information provided by Chevron Phillips Chemical Company.