POLYMER SEARCH

BASF Ultramid® KR 4350 PA6/6T (Conditioned)

Category	Polymer , Thermoplastic , Nylon , Nylon 6 , Nylon 6, Unreinforced
Manufacturer	BASF
Trade Name	Ultramid®
Port	Ningbo port,China
Trade Terms	FOB, CFR, CIF
Payment Terms	L/C, T/T, Western Union
Download PDF	BASF Ultramid® KR 4350 PA6/6T (Conditioned).pdf
Price	EMAIL US sales@lookpolymers.com

Material Notes:

Description: For injection-molding and extrusion, exhibiting high toughness, strength and stiffness, low water absorption, high melting point (295 °C [563°F]). The mechanical properties remain constant after moisture absorption up to a temperature of 60°C [140°F].Information provided by BASF

Physical Properties	Metric	English	Comments
Density	1.16 g/cc	0.0419 lb/in³	ISO 1183
Water Absorption	6.5 - 7.5 %	6.5 - 7.5 %	Saturation; ISO 62
Moisture Absorption at Equilibrium	1.6 - 2.0 %	1.6 - 2.0 %	23°C; 50% RH; ISO 62
Viscosity Measurement	130	130	ISO 307
Linear Mold Shrinkage	0.0060 cm/cm	0.0060 in/in	restricted

Mechanical Properties	Metric	English	Comments
Tensile Strength, Yield	90.0 MPa	13100 psi	50 mm/min; ISO 527-1/-2
Modulus of Elasticity	3.20 GPa	464 ksi	ISO 527-1/-2
Tensile Creep Modulus, 1000 hours	2300 MPa @Strain <=0.500 %	334000 psi @Strain <=0.500 %	ISO 899-1

Thermal Properties	Metric	English	Comments
Specific Heat Capacity	1.50 J/g-°C	0.359 BTU/lb-°F
Thermal Conductivity	0.230 W/m-K	1.60 BTU-in/hr-ft²-°F	DIN 52612
Melting Point	295 °C	563 °F	DIN 53765
Maximum Service Temperature, Air	110 °C	230 °F	for 50% loss of tensile strength after 20000hr
	130 °C	266 °F	for 50% loss of tensile strength after 5000hr
	250 °C	482 °F

Electrical Properties	Metric	English	Comments
Volume Resistivity	1.00e+12 ohm-cm	1.00e+12 ohm-cm	IEC 60093
Surface Resistance	1.00e+12 ohm	1.00e+12 ohm	IEC 60093
Dielectric Constant	4.0 @Frequency 1.00 Hz	4.0 @Frequency 1.00 Hz	IEC 60250
Dissipation Factor	0.040 @Frequency 1.00e+6 Hz	0.040 @Frequency 1.00e+6 Hz	IEC 60250
Comparative Tracking Index	600 V	600 V	Test solution A; IEC 60112

Processing Properties	Metric	English	Comments
Melt Temperature	310 - 330 °C	590 - 626 °F	Injection-molding/Extrusion
Mold Temperature	70.0 - 100 °C	158 - 212 °F	Injection-molding

Descriptive Properties	Value	Comments
Commercial Status	Europe

Users viewing this material also viewed the following: