PolyOne Versollan™ RU 2205-9 Thermoplastic Elastomer (TPE)

Versollan™ RU 2205-9 is the first of a new class of high performance, injection moldable TPU alloys developed to offer a rubbery feel and appearance, reduced cycle times, combined with the performance properties associated with TPUs. New Product. Commercial specifications have not been established. - Bonds to PC, ABS, PC/ABS, and Copolyester - Excellent Abrasion Resistance - Fast Set Up Rates During Processing - Matte Finish - Rubbery, Soft Touch Feel - Very Good Oil ResistancePurge thoroughly before and after use of this product with a low flow (0.5 - 2.5 MFR) polyethylene (PE) or polypropylene (PP). Regrind levels up to 20% can be used with Versollan™ RU 2205-9 with minimal property loss, provided that the regrind is free of contamination. To minimize losses during molding, the melt temperature should remain as low as possible. The final determination of regrind effectiveness should be determined by the customer. Versollan™ RU 2205-9 should not be left in the barrel for extended idle periods (greater than 5 minutes). Suggested Dewpoint: -40°F Injection Speed: 0.5 to 2 in/sec 1st Stage - Boost Pressure: 300 to 700 psi 2nd Stage - Hold Pressure: 30% of Boost Hold Time (Thick Part): 4 to 10 sec Hold Time (Thin Part): 1 to 3 secInformation provided by PolyOne