Formosa Plastics Formolene® HB5502Z Blow Molding HDPE

Hexene CopolymerApplications: Injection blow molded pharmaceutical packagingFormolene HB5502Z eliminates the need for including a mold release agent at each machine, by incorporating zinc stearate with the resin. This incorporation assures uniform consistent release properties. It may be used as an injection blow molding resin.Produced using licensor formulation for HHM 5502BZ. Licensor does not warrant or imply that this product meets their specifications for HHM 5502BZ.Meets all requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles intended for direct food contact.Nominal properties reported herein were determined on compression molded specimens prepared in accordance with Procedure C of ASTM D1928. Physical properties are typical of product but do not reflect normal testing variance and therefore should not be used for specification purposes.Information provided by Formosa Plastics Corporation, USA.