Material Notes:
Description: These are compounds containing a high percentage of magnetizable fillers; compared to traditional techniques for the manufacture of magnets, this allows the molding of complex shapes using injection molding. To obtain permanent magnetization values, molded parts must then be submitted to the action of a magnetic field. All magnetizable LATI thermoplastics are 'hard' magnetic materials of the permanent type which will therefore require high demagnetizing power (high Hc). Magnetic values shown in the charts are obtained on molded parts using traditional processing methods; for particular requirements, higher values may be obtained using special techniques. APPLICATIONS: deflection yokes for TV sets, parts for small electric motors, components for meters and video-recorders, permanent magnets for various applications. Specific Notes for this Material: PA 12 base; fair flowability; high contents of special magnetizable fillers for superior magnetic performances, especially with orientation during molding.Disclaimer from LATI: This document contains information based on average values as obtained from the results of laboratory tests and observations made on LATI materials. Tested materials were injection molded, used in their natural color, and conditioned in compliance with Standard ASTM D 618, procedure A. These values refer to LATI's best technical and scientific knowledge at the moment of testing and cannot be used as a basis for the development of applications. For a better assessment of the materials, you are kindly requested to contact LATI's technical or commercial offices, which are at your disposal and will supply detailed information on the most suitable characteristics for their intended use. With reference to DPR n.224 dated May 24, 1988, issued in accordance with EC Guide-lines 85/374, LATI Industria Termoplastici S.p.A. declines all responsibility arising from an improper use of the products described in this document.All data provided by LATI.
